Command line option for automatic IP address detection

Started by chrisrwebb

chrisrwebb

Command line option for automatic IP address detection   09 September 2014, 03:21

Would it be possible to get a command-line option to tell the scanner to auto-detect the computer's network IP address information to perform a scan? This way the scanner could scan a network without an IP range having to be set. I know it can be done in the GUI wondering if there could be a command-line switch for it?

Thanks,
Chris
SoftPerfect Support forum - Andrew avatar image

Re: Command line option for automatic IP address detection   09 September 2014, 10:56

There is currently no command line switch for this (it's potentially dangerous to have one as if there are multiple network interfaces with large IP address space, the scan might take months or simply run out of memory).

Reply to this topic

Sometimes you can find a solution faster if you try the forum search, have a look at the knowledge base, or check the software user manual to see if your question has already been answered.

Our forum rules are simple:

  • Be polite.
  • Do not spam.
  • Write in English. If possible, check your spelling and grammar.

Author:

Email:

Subject

A brief and informative title for your message, approximately 4–8 words:

     

Spam prevention: please enter the following code in the input field below.

 **     **  ********   **          ******    **     ** 
 **     **  **     **  **    **   **    **    **   **  
 **     **  **     **  **    **   **           ** **   
 **     **  ********   **    **   **   ****     ***    
  **   **   **         *********  **    **     ** **   
   ** **    **               **   **    **    **   **  
    ***     **               **    ******    **     ** 

Message: