Adding ignored IP addresses to command line

Started by Patrick

Patrick

Adding ignored IP addresses to command line   19 February 2020, 10:30

We currently use the Network Scanner via command line. My question is, how do I add ignored IP addresses to the command line?
Additional to that, as I scan multiple sub-nets, I would have different exclusions for each sub-net.
SoftPerfect Support forum - Ann avatar image
Ann

Re: Adding ignored IP addresses to command line   19 February 2020, 10:48

There is no specific command line parameter for excluding IP addresses because it is read from the default configuration file.

You can create one or more configurations with your subnets and exclusions and then supply them with the /config:filename.xml parameter. Please note that the entire configuration will be read from that file, including subnets and exclusions.

Reply to this topic

Sometimes you can find a solution faster if you try the forum search, have a look at the knowledge base, or check the software user manual to see if your question has already been answered.

Our forum rules are simple:

  • Be polite.
  • Do not spam.
  • Write in English. If possible, check your spelling and grammar.

Author:

Email:

Subject

A brief and informative title for your message, approximately 4–8 words:

     

Spam prevention: please enter the following code in the input field below.

  *******   **      **  ********    ******   **       
 **     **  **  **  **  **     **  **    **  **       
        **  **  **  **  **     **  **        **       
  *******   **  **  **  ********   **        **       
        **  **  **  **  **     **  **        **       
 **     **  **  **  **  **     **  **    **  **       
  *******    ***  ***   ********    ******   ******** 

Message: