Command line: HTML output and batch commands

Started by kiwi_rock

Command line: HTML output and batch commands   27 March 2006, 12:13

Hey Andrew,

Is there anyway the basic net scanner can be set to scan a specified range and save an html file from the command line? I wouldn't mind scheduling it to run now and then automated.

Re: html output/batch commands?   27 March 2006, 12:24

Off topic, but I also noticed the MAC addresses are coming up with 8 bytes sometimes instead of 6, such as the local ethernet adaptor being 00-C0-DF-02-E7-EA-00-00. Strange. Yet other IP's are fine such as a router 00-0F-3D-B1-54-73.
SoftPerfect Support forum - Andrew avatar image

Re: html output/batch commands?   27 March 2006, 20:01

1. Yes, have a look at user's manual at the bottom of the page. You probably need the /auto and /range switches.

2. This is kind of a bug, but non-critical. Two ending zeros are added every time when the scanner looks up the local MAC address.

Reply to this topic

Sometimes you can get the answer faster if you try the forum search and/or have a look at the software user manual to see if your question has already been answered.

Our forum rules are simple:

  • Be polite.
  • Do not spam.
  • If possible, check your spelling and grammar.

Author:

Email:

Subject

A brief and informative title for your message, approximately 4–8 words:

     

Spam prevention: please enter the following code in the input field below.

 ********  ********   **     **  ********  **      ** 
    **     **     **   **   **      **     **  **  ** 
    **     **     **    ** **       **     **  **  ** 
    **     ********      ***        **     **  **  ** 
    **     **           ** **       **     **  **  ** 
    **     **          **   **      **     **  **  ** 
    **     **         **     **     **      ***  ***  

Message: