Command line: HTML output and batch commands

Started by kiwi_rock

Command line: HTML output and batch commands   27 March 2006, 11:13

Hey Andrew,

Is there anyway the basic net scanner can be set to scan a specified range and save an html file from the command line? I wouldn't mind scheduling it to run now and then automated.

Re: html output/batch commands?   27 March 2006, 11:24

Off topic, but I also noticed the MAC addresses are coming up with 8 bytes sometimes instead of 6, such as the local ethernet adaptor being 00-C0-DF-02-E7-EA-00-00. Strange. Yet other IP's are fine such as a router 00-0F-3D-B1-54-73.
SoftPerfect Support forum - Andrew avatar image

Re: html output/batch commands?   27 March 2006, 19:01

1. Yes, have a look at user's manual at the bottom of the page. You probably need the /auto and /range switches.

2. This is kind of a bug, but non-critical. Two ending zeros are added every time when the scanner looks up the local MAC address.

Reply to this topic

Sometimes you can find a solution faster if you try the forum search, have a look at the knowledge base, or check the software user manual to see if your question has already been answered.

Our forum rules are simple:

  • Be polite.
  • Do not spam.
  • Write in English. If possible, check your spelling and grammar.

Author:

Email:

Subject

A brief and informative title for your message, approximately 4–8 words:

     

Spam prevention: please enter the following code in the input field below.

 ********   **    **  ********   ********  **    ** 
 **     **  ***   **  **     **     **     **   **  
 **     **  ****  **  **     **     **     **  **   
 ********   ** ** **  ********      **     *****    
 **     **  **  ****  **            **     **  **   
 **     **  **   ***  **            **     **   **  
 ********   **    **  **            **     **    ** 

Message: