SoftPerfect RAM Disk

Unable to complete system state backup once RamDrive installed

Started by FrankG

Using a third part backup solution. Since the install and config of a RAMDrive, the system state back has failed. Anyone run into this issue?
SoftPerfect Support forum - Andrew avatar image

Re: Unable to complete system state backup once RamDrive installed   12 January 2016, 09:59

Try turning on HDD emulation in the RAM Disk's properties. Some apps don't support standalone volumes and require a full hard disk drive to be emulated.

Reply to this topic

Sometimes you can find a solution faster if you try the forum search, have a look at the knowledge base, or check the software user manual to see if your question has already been answered.

Our forum rules are simple:

  • Be polite.
  • Do not spam.
  • Write in English. If possible, check your spelling and grammar.

Author:

Email:

Subject

A brief and informative title for your message, approximately 4–8 words:

     

Spam prevention: please enter the following code in the input field below.

 ********  **     **  **     **  ********        ** 
 **        **     **  **     **     **           ** 
 **        **     **  **     **     **           ** 
 ******    **     **  **     **     **           ** 
 **        **     **   **   **      **     **    ** 
 **        **     **    ** **       **     **    ** 
 ********   *******      ***        **      ******  

Message: