One rule for each ip?

Started by Faraz

Faraz

One rule for each ip?   05 May 2012, 19:43

AOA.
Is there any Way. to create a single rule for assign same bandwidth to all ip address of a series

e.g
i want to assign 700KB to Each ip address in 192.168.0.5-192.168.0.255. instead of creating 250 rules for all single single ip address.

is there any way to create only single rules. which assign 700 kb speed to each ip address from the above ip series
Wayne

one Rule for each ip?   30 October 2012, 23:40

You can use tools--->add batch to create one rule for many single ip addresses. But you should modify this batch rule very carefully 'cause all the settings you create will affect directly to many single ip and will be difficult to modify each rule again later. Thanks!

Sometimes you can get the answer faster if you try the forum search and/or have a look at the software user manual to see if your question has already been answered.

Our forum rules are simple:

  • Be polite.
  • Do not spam.
  • If possible, check your spelling and grammar.

Author:

Email:

Subject

A brief and informative title for your message, approximately 4–8 words:

     

Spam prevention: please enter the following code in the input field below.

 **     **  **     **   *******   ********  **        
 **     **  ***   ***  **     **     **     **    **  
 **     **  **** ****         **     **     **    **  
 **     **  ** *** **   *******      **     **    **  
 **     **  **     **         **     **     ********* 
 **     **  **     **  **     **     **           **  
  *******   **     **   *******      **           **  

Message: