10 Gb/s shaping

Started by maghnuz

maghnuz

10 Gb/s shaping   29 January 2016, 05:48

Hi guys! I have a question about the SoftPerfect Bandwidth Manager.
I would like to make a 10 Gb/s rule, when i do this I get a message that it is not a correct integer.
Is there any way to make a 10 Gb/s rule?

Thank you!
SoftPerfect Support forum - Andrew avatar image

Re: 10 Gb/s shaping   29 January 2016, 09:30

No, there is no way. The software can't handle more than 300-500 Mbps and I doubt any software can.

You'd need a hardware shaper like this, but even then 10 Gbps is the theoretical maximum.

Reply to this topic

Sometimes you can find a solution faster if you try the forum search, have a look at the knowledge base, or check the software user manual to see if your question has already been answered.

Our forum rules are simple:

  • Be polite.
  • Do not spam.
  • Write in English. If possible, check your spelling and grammar.

Author:

Email:

Subject

A brief and informative title for your message, approximately 4–8 words:

     

Spam prevention: please enter the following code in the input field below.

 **     **  ********   **    **  **     **  ********  
 **     **  **     **   **  **   **     **  **     ** 
 **     **  **     **    ****    **     **  **     ** 
 **     **  ********      **     **     **  **     ** 
  **   **   **     **     **      **   **   **     ** 
   ** **    **     **     **       ** **    **     ** 
    ***     ********      **        ***     ********  

Message: