Server 2008 with RRAS

Started by Leoco

Leoco

Server 2008 with RRAS   29 January 2010, 15:28

Hi,

I have been using BWM in Bridge mode and was playing around with using it on a 2008 server with Routing and Remote Access.

I did a basic setup with 2 nics, an inside and outside. I setup a few rules and cant seem to get to work correctly. Is BWM compatable with RRAS or am I just not doing something correctly.

Any Input would be appreciated.

Thanks

Leoco
SoftPerfect Support forum - Andrew avatar image

Server 2008 with RRAS   29 January 2010, 23:35

Yes, it is compatible. However you have to use either routing/NAT or bridging, but not both at the same time.

Reply to this topic

Sometimes you can get the answer faster if you try the forum search and/or have a look at the software user manual to see if your question has already been answered.

Our forum rules are simple:

  • Be polite.
  • Do not spam.
  • If possible, check your spelling and grammar.

Author:

Email:

Subject

A brief and informative title for your message, approximately 4–8 words:

     

Spam prevention: please enter the following code in the input field below.

 **    **  **     **  **     **   ******   **     ** 
  **  **   ***   ***  **     **  **    **  ***   *** 
   ****    **** ****  **     **  **        **** **** 
    **     ** *** **  **     **  **        ** *** ** 
    **     **     **   **   **   **        **     ** 
    **     **     **    ** **    **    **  **     ** 
    **     **     **     ***      ******   **     ** 

Message: