I just "upgraded" from copper to fiber, and AT&T "gave" me a new modem, a Pace 5031NV-030. Networx cannot see a connection, and I cannot figure out if there is an SNMP link that I don't see or if I just can't use this app. Any ideas appreciated, Networx has been a vital part of managing data limits.
Thanks.
Don't know what info is relevant, so what I know:
Broadband link-ADSL/VDSL
IP connection Direct IP(DHCP or Static)
Which offers me no info. I have lots of other parameters displayed, but nothing seems relevant.
SoftPerfect NetWorx
Updated to AT&T Fiber DSL, can't find SNMP
Started by The Soundsmith
The Soundsmith
Updated to AT&T Fiber DSL, can't find SNMP 21 April 2016, 02:53 |
Re: Updated to AT&T Fiber DSL, can't find SNMP 21 April 2016, 08:29 |
Admin Registered: 18 years ago Posts: 3 519 |
Unfortunately, there isn't much we can help you with. The official data sheet doesn't mention UPnP or SNMP, so probably those are not supported.
The SOundsmith
Re: Updated to AT&T Fiber DSL, can't find SNMP 21 April 2016, 13:58 |
The Soundsmith
Are there options? 23 April 2016, 02:20 |
Re: Are there options? 23 April 2016, 09:09 |
Admin Registered: 18 years ago Posts: 3 519 |
I am not sure if any app in existence can monitor a router that doesn't support UPnP or SNMP. This just doesn't seem possible.
As far as I can tell GlassWire is a firewall/traffic monitor that only monitors the computer it's installed on. NetWorx does the same when you don't set it to monitor a router.
As far as I can tell GlassWire is a firewall/traffic monitor that only monitors the computer it's installed on. NetWorx does the same when you don't set it to monitor a router.
johnybgood
Re: Are there options? 06 June 2016, 05:08 |
johnybgood
Re: Are there options? 06 June 2016, 05:12 |