Networx with NAS Synology

Started by Sylvain

Sylvain

Networx with NAS Synology   19 July 2016, 19:20

Hello!
How to set up my NAS Synology with Networx?

On a remote desktop (192.168.1.165), I install Networx with these settings: I ticked SNMP, wrote the NAS IP (192.168.1.5), chose the WAN interface (eth1).
It seems to work...
With these settings, Networx monitors all traffic with the NAS. But I would to monitor only traffic between NAS and gateway (192.168.1.1). An advice? A trick? Impossible?

Thanks for your reply
SoftPerfect Support forum - Andrew avatar image

Re: Networx with NAS Synology   19 July 2016, 19:43

Impossible, I'm afraid. The SNMP counters provide the number of bytes sent and received over an interface, but there is no way to separate it by IP address.
Sylvain

Re: Networx with NAS Synology   19 July 2016, 22:12

sad

by another way???
SoftPerfect Support forum - Andrew avatar image

Re: Networx with NAS Synology   19 July 2016, 22:53

Nope, unless there is some kind of app for the NAS itself.
Sylvain

Re: Networx with NAS Synology   20 July 2016, 00:16

OK
Thanks

Reply to this topic

Sometimes you can find a solution faster if you try the forum search, have a look at the knowledge base, or check the software user manual to see if your question has already been answered.

Our forum rules are simple:

  • Be polite.
  • Do not spam.
  • Write in English. If possible, check your spelling and grammar.

Author:

Email:

Subject

A brief and informative title for your message, approximately 4–8 words:

     

Spam prevention: please enter the following code in the input field below.

 **     **   ******   ********   **     **  **     ** 
 **     **  **    **  **     **  **     **  **     ** 
 **     **  **        **     **  **     **  **     ** 
 **     **  **        **     **  **     **  **     ** 
  **   **   **        **     **  **     **   **   **  
   ** **    **    **  **     **  **     **    ** **   
    ***      ******   ********    *******      ***    

Message: