Greetings,
Does the NetWorx software support unattended installs using any kind of answer file for the settings?
Regards,
Joe
SoftPerfect NetWorx
Unattended installation
Started by Joe
Joe
Unattended installation 23 October 2020, 10:15 |
Re: Unattended installation 23 October 2020, 10:37 |
Admin Registered: 10 years ago Posts: 889 |
You can install NetWorx using
To install specific components only, use
If you want NetWorx to have specific settings, you can replace its initial database with all the settings. To do that,
networx_setup.exe /SILENTin the command line. This will install it automatically, without user intervention.
To install specific components only, use
/COMPONENTS="comma separated list of component names"where the available components are:
- main (the application itself)
- deskband (the taskbar extension)
- netfilter (LAN traffic filtering driver)
If you want NetWorx to have specific settings, you can replace its initial database with all the settings. To do that,
- Download portable version of NetWorx to a folder.
- Set the settings the way you want.
- Quit NetWorx and you will find NETWORX.DB in that folder.
- Copy the file to %ALLUSERSPROFILE%\SoftPerfect\NetWorx\ after NetWorx was installed on a new computer.
Re: Unattended installation 27 March 2022, 08:30 |
Registered: 2 years ago Posts: 1 |
Good greetings!
When using the command
It means that the installation is no longer silent. Is there a solution?
When using the command
networx_setup.exe /SILENT /COMPONENTS="deskband"silent install works fine, but I still get the message "do you want to integrate the program into deskband", despite the use of /COMPONENTS="deskband"
It means that the installation is no longer silent. Is there a solution?
Re: Unattended installation 27 March 2022, 15:40 |
Admin Registered: 18 years ago Posts: 3 518 |