Helper program for Admin-only Mode

Started by rmpf2

rmpf2

Helper program for Admin-only Mode   24 August 2019, 03:39

Every time I try to do a scan that uses an nmap request on one of its columns, a popup window appears:
Quote

User Account Control
Do you want to allow this app to make changes to your device?
The helper program for "Admin-only Mode"
Program location: …….. \NpcapHelper.exe"npcap-35352 35352


This occur on Win 10 64bit PC.
SoftPerfect Support forum - Andrew avatar image

Re: Helper program for Admin-only Mode   24 August 2019, 20:15

It sounds like Npcap was installed with admin-only access, as shown below. The solution is obviously to reinstall it so that any user can access it.

SoftPerfect support forum

Reply to this topic

Sometimes you can find a solution faster if you try the forum search, have a look at the knowledge base, or check the software user manual to see if your question has already been answered.

Our forum rules are simple:

  • Be polite.
  • Do not spam.
  • Write in English. If possible, check your spelling and grammar.

Author:

Email:

Subject

A brief and informative title for your message, approximately 4–8 words:

     

Spam prevention: please enter the following code in the input field below.

 **    **   ******   **    **  **     **  ******** 
 ***   **  **    **  **   **   **     **     **    
 ****  **  **        **  **    **     **     **    
 ** ** **  **        *****     *********     **    
 **  ****  **        **  **    **     **     **    
 **   ***  **    **  **   **   **     **     **    
 **    **   ******   **    **  **     **     **    

Message: