How to set the source port

Started by Drazen

Drazen

How to set the source port   16 July 2020, 11:02

Hello!
Can you please give me an example how I can define source ports for a Bandwidth Manager rules? I was unable to find a example in the online manual.

In the Add/Edit Rule window, on the Source tab, I am entering 'Specific' in the Source Port box, but getting this error: "Incorrect input: for a specific port TCP or UDP must be used".
SoftPerfect Support forum - Ann avatar image
Ann

Re: How to set the source port   16 July 2020, 11:27

Simply choose IPv4 TCP/UDP under the protocol section on the General tab.

The concept of ports is only valid for transport protocols such as TCP and UDP. If the rule is configured to capture some other protocol(s), it will not let you choose ports, just as you describe.

Reply to this topic

Sometimes you can find a solution faster if you try the forum search, have a look at the knowledge base, or check the software user manual to see if your question has already been answered.

Our forum rules are simple:

  • Be polite.
  • Do not spam.
  • Write in English. If possible, check your spelling and grammar.

Author:

Email:

Subject

A brief and informative title for your message, approximately 4–8 words:

     

Spam prevention: please enter the following code in the input field below.

 ********   *******   ********   ********   *******  
    **     **     **  **     **  **        **     ** 
    **            **  **     **  **        **     ** 
    **      *******   ********   ******     ******** 
    **            **  **         **               ** 
    **     **     **  **         **        **     ** 
    **      *******   **         ********   *******  

Message: