How to run NetScanner on a schedule

Started by M.Todd

M.Todd

How to run NetScanner on a schedule   01 October 2019, 08:42

Is there a way to automatically run Network Scanner on a schedule?

Thanks
SoftPerfect Support forum - Ann avatar image
Ann

Re: How to run NetScanner on a schedule   01 October 2019, 09:10

Like any other program, it can be run by the Windows scheduler with some command-line parameters. Supported command-line switches are listed at the end of the Network Scanner user manual.

Note that if you schedule Network Scanner to run under a different user or SYSTEM user, you would need to specify the configuration file in the command line. Alternatively, use the portable version of Network Scanner: it will pick up the config file located in the same folder, no matter which user is running the application.

Reply to this topic

Sometimes you can find a solution faster if you try the forum search, have a look at the knowledge base, or check the software user manual to see if your question has already been answered.

Our forum rules are simple:

  • Be polite.
  • Do not spam.
  • Write in English. If possible, check your spelling and grammar.

Author:

Email:

Subject

A brief and informative title for your message, approximately 4–8 words:

     

Spam prevention: please enter the following code in the input field below.

 ********  **     **  **    **  **    **  ********  
 **        **     **  ***   **  **   **   **     ** 
 **        **     **  ****  **  **  **    **     ** 
 ******    **     **  ** ** **  *****     ********  
 **         **   **   **  ****  **  **    **        
 **          ** **    **   ***  **   **   **        
 **           ***     **    **  **    **  **        

Message: