How to change installer destination location when installing via CMD

Started by Mehdi

Hi,
Is it possible to change the destination folder of where the RAMdisk application should be placed when installing it through CMD?
Something like this:
ramdisk_setup.exe DestinationFoler="C:\RAMdisk\allfiles\"
SoftPerfect Support forum - Ann avatar image
Ann

Re: How to change installer destination location when installing via CMD   08 March 2021, 11:57

Yes, you can use the /DIR parameter for that. All command line parameters of Inno Setup are supported.
Quote

/DIR="x:\dirname"
Overrides the default directory name displayed on the Select Destination Location wizard page. A fully qualified pathname must be specified.

Reply to this topic

Sometimes you can find a solution faster if you try the forum search, have a look at the knowledge base, or check the software user manual to see if your question has already been answered.

Our forum rules are simple:

  • Be polite.
  • Do not spam.
  • Write in English. If possible, check your spelling and grammar.

Author:

Email:

Subject

A brief and informative title for your message, approximately 4–8 words:

     

Spam prevention: please enter the following code in the input field below.

 **              **  **    **  ********   ******** 
 **              **   **  **   **     **  **       
 **              **    ****    **     **  **       
 **              **     **     ********   ******   
 **        **    **     **     **         **       
 **        **    **     **     **         **       
 ********   ******      **     **         ******** 

Message: