I installed Networx on two Win7 computers, one is 32-bit and the other is 64-bit. After install both computers showed a yellow sign near Teredo Tunneling Pseudo-Interface in Device Manager. "This device cannot start. (Code 10)".
I re-enabled Teredo in the registry and it works normally again, but I was wondering why would you need to disable it in the first place? Thanks.
SoftPerfect NetWorx
Why was Teredo disabled?
Started by Alex
Alex
Why was Teredo disabled? 08 December 2013, 14:52 |
Re: Why was Teredo disabled? 08 December 2013, 15:09 |
Admin Registered: 18 years ago Posts: 3 519 |
Alex
Re: Why was Teredo disabled? 09 December 2013, 08:44 |
Re: Why was Teredo disabled? 09 December 2013, 10:08 |
Admin Registered: 18 years ago Posts: 3 519 |
I am not sure, as this is what the installation procedure of the traffic filtering driver does.
This is a third-party driver and they say Teredo may be disabled for the installation of a WFP driver, which is then re-enabled after a reboot.
I suppose if it's working fine for you, you don't need to do anything.
This is a third-party driver and they say Teredo may be disabled for the installation of a WFP driver, which is then re-enabled after a reboot.
I suppose if it's working fine for you, you don't need to do anything.
Alex
Re: Why was Teredo disabled? 09 December 2013, 13:17 |
Hussin
How to re-enable Teredo manually 03 July 2018, 13:33 |
Re: How to re-enable Teredo manually 03 July 2018, 16:03 |
Admin Registered: 18 years ago Posts: 3 519 |