Filtering scan results to show only unused IP addresses
3 posts · Closed
Donal Guest
Is there a way of filtering NetScanner scan results to show only IP addresses which are not being used?
Ann SoftPerfect
The easiest way would be:
- Go to Options - Program Options - General and tick Display inactive devices.
- Run a scan.
- Press Ctrl + I to open the filter pane, then choose Response time: Empty.
This will filter out all devices with a response time, leaving only those that did not respond (i.e. not being used).
Donal Guest
First class!
Thanks again
This topic is closed.
It has had no new posts for over a year, so the software versions it talks about may be out of date.
Start a new topic in Network Scanner if you have a similar question.