Change installation destination folder via CMD
2 posts · Closed
Mehdi Guest
Hi,
Is it possible to change the destination folder of where the RAMdisk application should be placed when installing it through CMD?
Something like this:
ramdisk_setup.exe DestinationFolder="C:\RAMdisk\allfiles\"
Ann SoftPerfect
Yes, you can use the /DIR parameter for that. All command line parameters of Inno Setup are supported.
/DIR="x:\dirname"
Overrides the default directory name displayed on the Select Destination Location wizard page. A fully qualified pathname must be specified.
This topic is closed.
It has had no new posts for over a year, so the software versions it talks about may be out of date.
Start a new topic in RAM Disk if you have a similar question.