Running SCE as a service

Started by procisco

procisco

Running SCE as a service   14 August 2015, 23:54

Hello, I'm a new user of your Connection Emulator software. I would like to have SCE running all the time. Is there an option to make it a service? I believe that adding a shortcut to startup will launch SCE, but then a user will have to manually click "start". The host PC is occasionally rebooted for maintenance in off hours and I would like SCE to be running after the reboot without user intervention.

Thanks and Regards,
John k.
SoftPerfect Support forum - Andrew avatar image

Re: Running SCE as a service   15 August 2015, 18:59

Unfortunately it can't run as a service as it was designed to be an interactive application. There's however a way to launch it automatically, please see command line switches at the bottom of this document. You could either use /runtime:X where X is a large number or save the current config to a XML file and feed it in the command line.

Sometimes you can get the answer faster if you try the forum search and/or have a look at the software user manual to see if your question has already been answered.

Our forum rules are simple:

  • Be polite.
  • Do not spam.
  • If possible, check your spelling and grammar.

Author:

Subject

A brief and informative title for your message, approximately 4–8 words:

     

Spam prevention: please enter the following code in the input field below.

 **     **   ******     *******    ******   **    ** 
  **   **   **    **   **     **  **    **  **   **  
   ** **    **         **         **        **  **   
    ***     **   ****  ********   **        *****    
   ** **    **    **   **     **  **        **  **   
  **   **   **    **   **     **  **    **  **   **  
 **     **   ******     *******    ******   **    ** 

Message: