SoftPerfect Connection Emulator

Running SCE as a service

Started by procisco


Running SCE as a service   14 August 2015, 23:54

Hello, I'm a new user of your Connection Emulator software. I would like to have SCE running all the time. Is there an option to make it a service? I believe that adding a shortcut to startup will launch SCE, but then a user will have to manually click "start". The host PC is occasionally rebooted for maintenance in off hours and I would like SCE to be running after the reboot without user intervention.

Thanks and Regards,
John k.
SoftPerfect Support forum - Andrew avatar image

Re: Running SCE as a service   15 August 2015, 18:59

Unfortunately it can't run as a service as it was designed to be an interactive application. There's however a way to launch it automatically, please see command line switches at the bottom of this document. You could either use /runtime:X where X is a large number or save the current config to a XML file and feed it in the command line.

Reply to this topic

Sometimes you can find a solution faster if you try the forum search, have a look at the knowledge base, or check the software user manual to see if your question has already been answered.

Our forum rules are simple:

  • Be polite.
  • Do not spam.
  • Write in English. If possible, check your spelling and grammar.




A brief and informative title for your message, approximately 4–8 words:


Spam prevention: please enter the following code in the input field below.

 **     **  **         ******   **         **    ** 
 **     **  **        **    **  **    **   **   **  
 **     **  **        **        **    **   **  **   
 **     **  **        **        **    **   *****    
 **     **  **        **        *********  **  **   
 **     **  **        **    **        **   **   **  
  *******   ********   ******         **   **    **