Hello!
I know it is not supported yet, but I was using Networx to monitor data usage through my Netgear router on Windows 10. I'm sure this was up and running ok in a previous build, but I've just installed the latest build (9926) and noticed that the upload/download graph was empty. Going into settings and clicking through "monitor my router" the dropdowns for gateway and wan interface are now blank in the UPNP section (I recall SNMP didn't work, but I'm sure I must have selected something previously in the UPNP section?) There is a router UUID on the main interface dropdown that also doesn't show up any data when selected. I'm guessing something changed in the latest Windows build? I also tried re-installing with the other driver in Networx setup.
Any help/suggestions gratefully received.
Derek
SoftPerfect NetWorx
Empty interface lists after updating Windows 10
Started by DerekH
DerekH
Empty interface lists after updating Windows 10 24 January 2015, 20:47 |
Re: Empty interface lists after updating Windows 10 25 January 2015, 10:31 |
Admin Registered: 18 years ago Posts: 3 519 |
DerekH
Re: Empty interface lists after updating Windows 10 - Solved 25 January 2015, 21:59 |
Hi Andrew,
Thanks for the reply - just sorted this. For some reason I noticed that upon update my wi-fi network had been set to public as opposed to private. I'm assuming switching it back to private enabled UPnP along with file sharing etc.. The router was then showing in the settings dropdown
Derek
Thanks for the reply - just sorted this. For some reason I noticed that upon update my wi-fi network had been set to public as opposed to private. I'm assuming switching it back to private enabled UPnP along with file sharing etc.. The router was then showing in the settings dropdown
Derek
Graeme
Networx will not run after windows 10 installation 02 August 2015, 19:08 |
I have just finished installing/upgrading from windows 7 ultimate (64 bit) to windows 10 pro (64 bit). the 1st message that I received was that networx was not running - I re-installed networx with the latest version and tried again - same error - I deleted/removed all versions - downloaded the latest version (5.4) did a fresh install and have got the same problem - it will not show the graphic icon in the tool bar - it will not open at all and will not run - what do I do to solve this problem. please help.
Re: Networx will not run after windows 10 installation 02 August 2015, 21:12 |
Admin Registered: 18 years ago Posts: 3 519 |